aPraktika
aPraktika
aPraktika

ZA 22 Mould Silicone, Addition Cure, 22 ShA

Stock: 100g (2X50):  0 pcs
200g (2X100):  1 pcs
400g (2X200):  4 pcs
ZA 22 Mould Silicone, Addition Cure, 22 ShA
ZA 22 Mould Silicone, Addition Cure, 22 ShA
ZA 22 Mould Silicone, Addition Cure, 22 ShA
ZA 22 Mould Silicone, Addition Cure, 22 ShA

ZA 22 is a two-component RTV silicone rubber, which is especially recommended for making moulds for polyester resins and concrete (concrete jewellery ) casting.


It is also suitable for use with polyurethane resin, acrylic resin, epoxy resin and vinyl ester resin but usually does not adhere to plasters, coatings, paints either.


Perhaps this is the most widespread, widely used and well known silicone. It has a short hardening time and very good tear resistance.



Main Application Areas:

Mould manufacturing and modeling with significant reproductive accuracy, with high dimensional stability and excellent mechanical performance.


It is used to cast artistic ceramics because it is the best choice for sampling and reproduction of surfaces with rich detail due to its high fluidity and low viscosity.



Its high tear resistance and tensile strength make it suitable for concrete moulding. Mockup makers and rc builders successfully use this silicone to produce smaller plastic parts with complicated geometry.


For more technical parameters and application please visit the details tab.

Manufacturer:
Zhermack
Shipping Cost :
4,7 €
7.18
To Favourites
Recommend
Print
Question about the product
Info
Details
Similar products
Opinions
Details

The curing process may be prevented by the following:

You have to take special care when using additive silicone systems.


While you handle and mix the silicone elastomer components, make sure that all mixing tools (vessels, spatula, mixer, etc.) are clean and made of materials that do not affect the curing process or chemical reaction.

Do not use wood and paper mixer!


The following materials may also inhibit the polymerization of the silicone resin:

  • the presence of nitrogen, sulfur, phosphorus and arsenic
  • compounds
  • organic tin catalysts
  • PVC stabilizers
  • epoxy resin catalysts



In addition, the following materials, products or materials containing them should also be kept away.

  • moulding clay
  • sulfur vulcanized tires
  • condensation silicone rubber
  • wood, paper, onion and garlic.

Similar products
Info
Color
Raw material state
liquid
Pot life
15 minute
Curing time
1 hour
Viscosity
4 000 mPas
Heat Resistance
-40 – 201 degree Celsius
Tear resistance
20 N/mm
Shore Hardness
22 ShA
Mix Ratio
100 : 100 by weight
Tensile Strength
4 MPa
Stock
100g (2X50):  0 pcs
200g (2X100):  1 pcs
400g (2X200):  4 pcs
Article No.
ASZ003
Status
In Stock    
Weight
110 g/pcs
Opinions
Be the first to review this product!
WebShop System